Broadcast, Multicast, Unicast would be the target for the Strom control function. Then does that ...
Strom control function has been configurated for each transmission respectively. ■ Unicast: 200,000 pps ■ Multicast: several hundred pps ■ Broadcast: ... Show Details
Is the implementation of Storm control function would be applied to both unicast transmissions of...
The Storm control function is applied to the connection port and switch of the Co-Location circuit, therefore both J-GATE and arrowhead will be targeted, and... Show Details
We would like to conduct Network reachability test to an institution other than JPX, what do we d...
Please apply via arrowface for the network reachability test. Please refer to [arrowface Operation Manual 2-1-5.Reserving NW reachability test] for details.... Show Details
We have received an e-mail saying that the network reachability test has been completed. Does tha...
The line is ready to be used. However, you will have to pass the user connectivity test for each system before using services. Show Details
In the case of the connection port being shut by the storm control function, can the end user dir...
JPX does not contact end users directly. Please kindly contact us via the contractor of the subjected arrownet line(s). Show Details
We would like to confirm IP address being advertised from the arrownet
Please contact JPX Service Desk (arrownet support) by phone call or e-mail us with the required information. (In case of emergency, please call us.) 【I... Show Details
Is it possible to inform arrownet users the number of packets detected by JPX?
JPX inform arrownet users the number of packets detected at a certain point if the subjected arrownet ID is provided. Show Details
Please kindly inform us the status of arrownet line.
We would like to confirm the connectivity status including its occurrence of transmission failure, please have the required information below filled in and... Show Details
In the arrowface portal, there are some arrownet line(s) that show status as “Monitoring on” desp...
For the line(s) that has been registered monitoring deactivation via e-mail or by phone call (except via arrowface), the status would show up as “Monitoring ... Show Details
I can not connect to arrownet, what should I do ?
Please confirm the following points. 1) You can start using arrownet after the Network Reachability Test is completed. In other words, it is not acce... Show Details
1-10 of Total 52